10Aruba 200 Series Access Points | Installation Guide
Power:
12 VDC power interface, supports powering through an AC-to-DC power adapter
POE support on Ethernet port: 802.3af-compliant POE sourcing devices
Connect Only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources
Connect Only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources
Proper Disposal of Aruba Equipment
Dispose of Aruba products per local regulation. For the most current information about Global Environmental Compliance and
Aruba products, see our website at www.arubanetworks.com.
Waste of Electrical and Electronic Equipment
Aruba products at end of life are subject to separate collection and treatment in the EU Member States, Norway,
and Switzerland and therefore are marked with the symbol shown at the left (crossed-out wheelie bin). The
treatment applied at end of life of these products in these countries shall comply with the applicable national
laws of countries implementing Directive 2002/96EC on Waste of Electrical and Electronic Equipment (WEEE).
China RoHS
Aruba products also comply with China environmental declaration requirements and are packaged with the “EFUP10” label shown
below.
If a power adapter other than the one provided by Aruba Networks is used in the US or Canada, it should be
cULus (NRTL) Listed, with an output rated 12 VDC, minimum 1.5A, marked “LPS” or “Class 2,” and suitable for
plugging into a standard power receptacle in the US and Canada.
The expected service life for this device is 10 years.
Changes or modifications to this unit not expressly approved by the party responsible for compliance c
the user’s authority to operate this equipment.