Arylic BT10 - Line in Mode; Optical in Mode

- 8 -
After successfully connected, the BT LED will stay on and you should be able to hear the sound coming
out from the connected Bluetooth device, and the connected output device through Aux out will have no
sound.
You can connect a second BT receiver device once the rst device has been successfully connected.
The procedure is the same.
Connecting the second device will take 20 to 50 seconds, please be patient.
Once connected, both BT receiver device will have sound output.
If you want to disconnect the BT connection, quickly press the device Play/Pause button twice to
disconnect the connection.
6.2 Line In Mode
You can connect any device with line/AUX output to BT10. Press the Mode button on the device or use
the remote controller or Go Control APP to switch to AUX mode. The AUX LED will turn on when in AUX
mode.
6.3 Optical In Mode
You can connect any device with optical output to BT10. Press the Mode button on the device or use
the remote controller or Go Control APP to switch to Optical mode. The OPT LED will turn on when in
Optical mode.