ASBER – BAR EQUIPMENT: Operations and Service Manual/ Rev. JUN. 2015
PAGE 11
4.6 ELECTRICAL CONNECTIONS
Refer to the amperage data in this manual or on data plate and your local code or the National
Electrical Code to be sure unit is connected to the proper power source. Verify correct incoming
voltage according to the Data Plate information.
HEAVY APPLIANCES
A protected circuit of the correct voltage and amperage must be run for connection of the
supply cord. Unit must be grounded and connected in accordance with NEC Article 422
Appliances.
4.7 SHELVING INSTALLATION
1) Hook shelf rails onto shelf pilasters
2) Position all two shelf rails equal in distance from the floor for level shelves.
3) Wire shelves are oriented so that cross support bars are facing down.
4) Place shelves on shelf clips making sure all corners are seated properly.
DANGER: Power must be turned off and disconnected from the power source
whenever performing maintenance, repair or cleaning the condensing unit.
If machine still running when power is off, disconnect power at the circuit breaker
before unplugging the machine.
WARNING: Machine and compressor warranties are void if failure is due
to improper electrical installation.
To Next Page
Loading...
