ASBER – BAR EQUIPMENT: Operations and Service Manual/ Rev. JUN. 2015
PAGE 12
5 OPERATION
5.1 ANALOG THERMOSTAT
Before y o u connect the unit to the power supply, verify the thermostat is NOT in the OFF position (the
position of the thermostat must be different than zero).If the thermostat is in the OFF position, the
compressor will not run. Keep in mind, the evaporator fan sand lights will still have power while the
thermostat is in the OFF position.
The knob of the thermostat is the temperature controller. T h i s is located inside the cabinet.
P
lease be
sure that the knob of thermostat is pointing to the yellow arrow (figure # 3).This position is
recommended by the factory to assure correct function of the equipment (see the figure #1 below).
Figure#1 Figure # 3
Note:
Keep in mind, if you move the knob to a different position that is recommend from factory, these
temperature will change, as well.
The knob position near the number one, gives you the warmest temperature and the knob position near
the number seven, gives you the coldest temperature.
Thermostat
Located inside
the unit in the
right side
Position
thermostat to
zero (0),
compressor will
not work.
For best
performance
knob should
be pointing
yellow mark
Knob to adjust
thermostat
setting
To Next Page
Loading...
