EasyManua.ls Logo

Ascend Group GTLT2 - 4. SMS Command List

Default Icon
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GTLT2 USER MANUAL
Page 8 of 21
flashlight once interval 8s GSM receiver work well and standby
Red LED---indicate charge sate
4. SMS Command List
Note: **** is GPS tracker user password and the default password is 0000. The tracker will only accept
commands from a user with the correct password. Commands with wrong password will be ignored.
Description SMS Command Example
Authorization
*Authorized phone number* user
password (default 0000) *location
number (1 or 2 or 3) **
*008613900000000*0000*1**(To set the first authorized
phone number)
*008613800000000*0000*2**(To set the second authorized
phone number)
*008613500000000*0000*3**(To set the third authorized
phone number)
Remarks: To authorize phone numbers for receiving location reports or SMS alarms or phone calls.
(1) Receiving SOS alert message: After press SOS button, GTLT2 will send sms alert and location coordinates to the first authorize phone number.
(2) Receiving Geo fence alert message: when the GTLT2 is in or out of the preset square, GTLT2 will send send sms alert and location coordinates to
the first authorize phone number.
Set Time Zone (Default:E0)
896****DNN 8960000E08
Remarks: This command is used for correct time into your local time
D=E/W, E means East Longitude, ahead of GTM time, W means West Longitude, behind GMT time.
NN is your time zone.
For example, China is in East Longtitude, GTM+8 time zone. Then we send 8960000E08
Change GPS Tracker user Password
777+New Password+Old Password 77712340000
Remarks: The password will be changed from 0000 to 1234
Enable SMS mode (Default mode)
700**** 7000000
Remarks: This command is used for turn on sms mode
Presetting by SMS for GPRS tracking (Ensure that your SIM card supports GPRS connection prior to setting)
Enable GPRS mode
710**** 7100000
The command to switch to GPRS mode.
Set APN (Default:cmnet)
Format 1:#803#****#APN##
Format 2:#803#****#APN# APN user
#803#0000#CMNET##
#803#0000# APN# APN user name#APN password ##
State Means
constant Lighting charging
flash weak charging was completed