2. IMPORTANT INSCRUCTOIN! WARNING! When installing the pedals DO
NOT use the wrench until you’ve done 4 FULL TURNS with your hand. If
the pedals are not well installed this will damage the crank arm
(The Right and left sides are defined as if you were sitting on the bike).
Start by taking the Right pedal marked with an R and place it on the right side
of bike, do the same thing for the left pedal.
Take the right pedal (12) in your hand and place it in front of the right crank
arm hole. Level it perfectly to make sure it’s aligned with the hole then start
turning the pedal CLOCKWISE into the crank arm (you shouldn’t feel ANY or
very little resistance, if you do stop immediately and start again) Once you’ve
done 4 FULL TURNS with your hand and that half of the screw is inside the
crank arm, you can finish it with the wrench.
Once the right pedal is installed, take the left pedal (13) in your hand and place
it in front of the left crank arm hole. Level it perfectly to make sure it’s aligned
with the hole then start turning the pedal COUNTERCLOCKWISE into the
crank arm (you shouldn’t feel ANY or very little resistance, if you do stop
immediately and start again) Once you’ve done 4 FULL TURNS with your
hand and that half of the screw is inside the crank arm, you can finish it with
the wrench.
STEP 2
ASSEMBLY INSTRUCTIONS
10
ASCEND SE MAGNETIC SPIN BIKE
24
To Next Page
Loading...