STEP 1
ASSEMBLY INSTRUCTIONS
9
ASCEND SE MAGNETIC SPIN BIKE
1. Fix the Front Stabilizer(2) to the main frame(1) with Carriage Bolts(16), Flat
washers(17) and cover nuts(18). Tighten with open wrench(25).
Fix the Rear Stabilizer(3) to the main frame(1) with Carriage Bolts(16), Flat
washers(17) and cover nuts(18). Tighten with open wrench(25).
ATTENTION : Make sure that the bike is perfectly leveled to the ground. To
level the bike use the adjustment knobs located under the front and rear
stabilizer.
24
To Next Page
Loading...