MANUFACTURER: ASEPCO,
1161 Cadillac Ct
Milpitas CA 95035
PRODUCT DESCRIPTION:
Pneumatic actuators are machined from 304 Stainless Steel and are designed to withstand
some dings and drops. All actuators have a position indicating shaft that extends when the
valve is open (for visual confirmation of valve position) and contain as few o-rings and
seals as possible which require very simple maintenance on an annual basis. Additionally,
to prevent any galling, we machine all our actuator bodies out of 304 Stainless Steel, our
diaphragm shafts out of 316 Stainless Steel and our actuator shafts out of Galltough or
304. All ASEPCO actuators can withstand operating temperature of 135° C (or 275° F).
PART NUMBERS:
PN05, PN10, PN20, PN30, PN40
APPLICABLE EUROPEAN DIRECTIVES:
ATEX: 2014/34/EC
APPLICABLE INTERNATIONAL STANDARDS:
ATEX: EN ISO 80079-36:2016, EN ISO 80079-37:2016
ISO 9001:2015 Quality Management System
NOTIFIED BODY
DNV Nemko Presafe AS, ATEX NB 2460 retains a copy of the Technical File
ATEX product marking: 2460 II2G Exc IIA T4
The product described in this Declaration of Conformity complies with the Applicable European
Directives and relevant sections of the Applicable International Standards. The signature on this
document authorizes the distinctive European mark to be applied to the equipment described. A
Technical Construction File is available for inspection by designated bodies.
Authorized Signature: Date: 11 May 2016
Important safety information is contained in the installation manual; read and
understand this information prior to installing or using this equipment.
This Document applies only to the equipment described above and is invalid if not reproduced in its entirety.
To Next Page
Loading...
Need help?
General
