4 m-radialdiaphragmvalve-en-02
2 Safety notes
This safety information should be used in conjunction with the rest of this operating
manual.
In the interests of safety, this valve and actuator should only be used by competent,
suitably trained personnel after they have read and understood the manual and considered
any hazard involved. If the valve is used in a manner not specified by ASEPCO, the
protection provided by the valve and actuator may be impaired. Any person who is
involved in the installation or maintenance of this equipment should be fully competent to
carry out the work. In the UK this person should also be familiar with the Health and Safety
at Work Act 1974 or its equivalent in other regions.
This symbol, used on the product and in the manual, means:
Possibility of severe personal injury, loss of life, or equipment damage
in indicated situation. Ensure all instructions are followed.
This symbol, used on the product and/or in the manual, means:
Caution, high pressure air and/or high process pressure hazard.
This symbol, used on the product and in the manual, means: Caution,
hot surface.
This symbol, used on the product and in the manual, means: Caution,
risk of electric shock.
This symbol, used on the product and in the manual, means: Personal
Protective Equipment (PPE) must be worn at all times.
Do not use ASEPCO products outside of their specified operating
range.
If valve is installed in a line carrying hazardous fluids then safety
procedures specific to the particular fluid and application must be put
in place to protect against injury to persons.
To avoid moisture build up and increased actuator wear, use only clean
dry air to operate pneumatic actuators.
To Next Page
Loading...
Need help?
General
