To Next PageTo Next Page
Need help?Do you have a question about the Ashly MFA-6000 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Total Power | 6000 W |
| Amplifier Class | Class D |
| Input Sensitivity | 1.4 V |
| Input Connectors | XLR, 1/4" TRS |
| DSP | No |
| Frequency Response | 20 Hz - 20 kHz |
| THD (Total Harmonic Distortion) | < 0.1% |
| Input Impedance | 20 kΩ |
| Protection | DC, thermal, short circuit |
| Output Connectors | Speakon, binding posts |
| Network Control | Yes |
| Signal-to-Noise Ratio | > 104 dB (A-weighted) |
| Height | 1.75" (1RU) |
| Dimensions (H x W x D) | 3.5" x 19" x 15.25" (89 mm x 483 mm x 387 mm) |
Specifies voltage, frequency, and current requirements for powering the amplifier.
Explains the importance of proper grounding to prevent hum and shock hazards.
Explains the red PROTECT LED, indicating fault conditions and automatic load disconnection.
Troubleshooting steps for scenarios with no audio output, covering power and indicator status.
Diagnosing and resolving distorted audio, checking clipping and signal levels.
Steps to identify and eliminate hum or buzz noise, checking grounding and connections.
Lists the output power ratings for various impedances and modes.
Specifies frequency response and total harmonic distortion levels.
Lists the various protection features for the amplifier and connected loads.
Explains the function of the front panel indicators (level meters, CLIP, LIMIT, THERM, PROTECT).
Lists AC power voltage, frequency, and current draw specifications.
