21
ADD ADDITIONAL RINSING
Proceed as follows to give an extra rinse in the Intensive, Strong and Normal wash:
Display Lamps
1. PRESS STRONG WASH FIVE TIMES* (WITHIN 15 SECONDS)
2. PRESS RINSE ONCE TO OBTAIN AN EXTRA RINSE 1
OR RESET:
2. PRESS QUICK WASH ONCE AND YOU WILL GET NORMAL FUNCTION -
* The latest selected setting will be shown.
SETTING THE WATER LEVEL
The machine takes in a suitable amount of water when the level reaches the mark on the lower spray
pipe bearing, see illustration. Check the level by opening the door after about 2 minutes during a
Normal programme. If there is insufficient water in the machine it may be due to extremely low
pressure of the water supply, in which case the input time can be modified. Some models are level
controlled, ie, the machine senses itself when the level is correct (but you can alter the level as follows
if you wish).
1. PRESS RINSE* FIVE TIMES (WITHIN 15 SECONDS)
2. PRESS NORMAL WASH ONCE FOR NORMAL INLET TIME 1
OR
2. PRESS QUICK WASH ONCE FOR 25% INCREASE IN INLET TIME 2
2. PRESS RINSE ONCE FOR 50% INCREASE IN INLET TIME 3
2. PRESS TEMPERATURE CHOICE ONCE FOR 100% INCREASE IN INLET TIME 4
2. PRESS HEATED DRYING ONCE FOR 150% INCREASE IN INLET TIME 5
* The latest selected setting will be shown.
Right level
To Next Page
Loading...
Need help?
General
