Asko D5233 - Setting Operational Signals; Wash Completion Signal Configuration

22
Customer Care Center
1-800-898-1879
www.askousa.com
Setting a signal
If you want the machine to signal when the wash is complete, you can program it to do this.
The machine is set without a signal by default.
1. Switch off the dishwasher at the main switch.
2. Hold in the Delayed start button at the same time as you press the
main switch. The button flashes. Release the button.
PROG PROG
3. Press the Program button – when the Auto wash symbol lights, the
signal is activated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next time
you want to make a change.
or Reset
1. Switch off the dishwasher with the main switch.
2. Hold in the Delayed start button at the same time as you press the
main switch. The button flashes. Release the button.
PROG PROG
3. Press the Program button – when the Auto wash symbol goes out, the
signal is deactivated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next time
you want to make a change.