37
Customer Care Center
1-800-898-1879
www.askousa.com
1. Connect drain hose
The drain hose is routed to an inlet plug on
the sink unit’s water trap.
Cut the drain hose adapter to the appro
priate size for connection to the undersink
drain or garbage disposer. The overall
length of the drain hose must not exceed
14 feet 9 inches.
No part of the drainage hose may be more
than 37-1/2 inches (950 mm) above the
bottom of the dishwasher. The hose must
not be run directly to the floor drain or simi-
lar.
The hose must always discharge at least
13-3/4 inches (350 mm) above the bottom
of the dishwasher.
2. Connect water supply hose
Use the supplied O ring and tighten the
connection by hand plus a quarter turn with
a wrench. Open the shutoff valve and let
the pressure settle for a while. Check the
connections again to make sure they are
not leaking.
3. Connect the plug
Ensure that the power outlet is within the
range of the power cable. Do not use an
extension cord!
The dishwasher must be connected to a
grounded outlet.
Plug
Water connection
Shutoff
valve
Grounded
outlet
Grounded
outlet
To Next Page
Loading...
