askona.com/specs
|
17
ASKO WASHERS AND DRYERS
Electrical
A separate electrical service is not required for the washer.
The receptacle for the washer is located on the back of the
dryer.
Installation must comply with all applicable electrical codes.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 240/208 VAC, 60 Hz
Service 30 amp
Plumbing
Installation must comply with all applicable plumbing codes.
PLUMBING REQUIREMENTS
Water Supply
1
/2" ID min (cold only)
Pressure 15–146 psi (1–10 bar)
To Next Page
Loading...
