Settings
Do as follows to open the settings menu:
DescriptionButton press
Turn off the dishwasher using the main power switch. Wait about five seconds.1.
Then press the main power switch again. Wait until the numbers appear in the right-hand display before
continuing to the next step.
Within five seconds, press and hold the Program selector (wait for the audible signal confirming the
button press) and then immediately press the Long dry button without releasing the Program selector.
+
2.
Keep the buttons pressed until the symbols for the Daily wash and Rinse & Hold programs start to
flash.
TIP!
Be sure to press right on the symbols, so as not to inadvertently activate any other button. Try again if you fail to open the settings menu
the first time.
Press to save the set value and continue to
the next setting.
Current setting.
Current setting value.
Press to browse between setting values.
Display
You can now adjust the following settings:
DescriptionSettingsOptionsButton press
You can activate the child lock (button lock) option
to prevent children from starting the dishwasher.
Child lock
(Kid Safe™)
(Off)
(On)
Press the High temperature and Long dry buttons
simultaneously to temporarily deactivate the button
lock when you want to start the dishwasher. The
button lock is automatically reactivated after 2 min-
utes.
Press Start/Stop to save the setting value and continue to the next setting.
If you do not want to change any other settings, keep pressing Start/Stop to step through the entire settings menu.
9
To Next Page
Loading...
Need help?
General
