Asko D5454 - Settings Menu; Accessing the Settings Menu; Adjusting Child Lock; Adjusting Buzzer Volume

SETTINGS
DO AS FOLLOWS TO OPEN THE SETTINGS MENU:
Turn off the dishwasher using the main power switch. Wait about five seconds.1.
Then press the main power switch again. Wait until the numbers appear in the right-hand display before continuing
to the next step.
2.
Within five seconds, press and hold the Program selector (wait for the audible signal confirming the button press)
and then immediately press the Long dry button without releasing the Program selector.
3.
+
Keep the buttons pressed until the symbols for the Daily wash and Rinse & Hold programs start to flash.4.
TIP!
Be sure to press right on the symbols, so as not to inadvertently activate any other button. Try again if you fail to
open the settings menu the first time.
P R O G
START
ST OP
Press to save the setting value and continue
to the next setting.
Current setting.
Current setting value.
Press to browse between setting values.
Display
YOU CAN NOW ADJUST THE FOLLOWING SETTINGS:
DescriptionSettingsOptionsButton press
You can activate the child lock (button lock) option
to prevent children from starting the dishwasher.
Child lock
(Kid Safe™)
(Off)
(On)
Press the High temperature and Long dry buttons si-
multaneously to temporarily deactivate the button
lock when you want to start the dishwasher. The
button lock is automatically reactivated after 2 min-
utes.
Press Start/Stop to save the setting value and continue to the next setting.
If you do not want to change any other settings, keep pressing Start/Stop to step through the entire settings menu.
The dishwasher uses a buzzer to indicate when a
program is finished or when a fault has occurred.
Buzzer volume
(Off)
(Low)
(High)
Press Start/Stop to save the setting value and continue to the next setting.
Customer Care Center 1-800-898-1879
www.askousa.com
10