Why do the buttons on my Asko DBI664IXXLSSOF Dishwasher not react when pressed?
If the buttons on your Asko dishwasher aren't responding, wait a moment and try again, especially if you've just opened the door. If the child lock is activated, refer to the Settings chapter for deactivation instructions. Remember, the buttons only work when the door is open. If the buttons are dirty, clean them with a dry or slightly damp cloth.
What causes sticky film on dishes in Asko DBI664IXXLSSOF Dishwasher?
If your Asko dishwasher leaves a sticky white/blue film on the dishes, the rinse aid dosage setting may be too high. Reduce the dosage. If you have very soft water, consider diluting the rinse aid 50:50 with water.
Why is there detergent residue in my Asko DBI664IXXLSSOF?
If you find detergent residue in the detergent compartment of your Asko dishwasher after washing, ensure the compartment is dry when adding detergent. Also, check that dishes are not blocking the detergent compartment from opening properly.
Why won't my Asko Dishwasher start?
If your Asko dishwasher doesn't start, make sure you press and hold the Start/Stop button until the display reads 'Program started, close door in 4 sec'. Ensure the door is fully closed within four seconds of pressing Start/Stop. Also, check the fuse/circuit breaker, the power plug, and the water supply valve. Inspect for any overflow/leaks. If you hear a whirring sound that doesn't stop, turn off the water supply, unplug the unit, and contact customer support. If the Delayed Start option is active, press and hold Start/Stop for three seconds to cancel it.
How to dry dishes in Asko Dishwasher?
If dishes in your Asko dishwasher are not dry enough, activate the Extra Dry option. Ensure the dishwasher is fully loaded and that the rinse aid is topped up with the correct dosage. Once the program finishes, open the door slightly to improve drying.
Why does my Asko Dishwasher leave spots on dishes?
If your Asko dishwasher leaves spots or films on the dishes, the rinse aid dosage setting might be incorrect. Also, high temperatures or excessive detergent can cause etching on crystal. Adjust the rinse aid dosage and wash crystal at a lower temperature with less detergent. Contact the detergent manufacturer for further advice.
How to clean dishes in Asko Dishwasher?
If your Asko dishwasher's dishes aren't clean, start by checking if the spray arms are blocked by dishes or if the spray arm holes are clogged. Choose a longer, more suitable dishwashing program and ensure you're using the correct detergent dosage based on your water hardness. Avoid using old detergent and make sure dishes are loaded correctly, without large bowls or lids covering them. Also, confirm that the filters are correctly fitted and that the drain pump stop is in place.
What causes spots or films on dishes in my Asko DBI664IXXLSSOF?
If your Asko dishwasher leaves spots or films on the dishes, see the Settings chapter for instructions on correcting the rinse aid dosage. If you are washing crystal, use a low temperature and a conservative amount of detergent. Contact the detergent manufacturer for further advice.
How to get rid of bad odor in Asko Dishwasher?
To address a bad odor in your Asko dishwasher, clean around the seals and in corners with a dish brush and low-foaming cleaner. If you frequently use low-temperature programs, run a high-temperature program or the self-cleaning program once or twice a month. If your dishwasher is connected to a garbage disposal, clean the disposal following the manufacturer's instructions.
What to do if water remains in Asko DBI664IXXLSSOF Dishwasher?
If your Asko dishwasher has water remaining above the filters, the filters may be blocked. Clean the coarse and fine filters. Also, ensure the filters are correctly fitted and the drain pump is free of debris. Check the drain hose for kinks or blockages.
General| Category | Dishwasher |
|---|---|
| Brand | Asko |
| Model | DBI664IXXLSSOF |
| Type | Built-in |
| Place settings | 16 |
| Child lock | Yes |
| Color | Stainless Steel |
| Noise level | 42 dB |
| Delay start | Yes |
To Next Page
