ActionType of fault on the display
Clear the drainage pump. See the chapter Care and cleaning. If
the problem persists, call the service department.
Overfilling water 1F10
See “Water remains in the dishwasher” in the table “Problem”
below. If the problem persists, call the service department.
Water outlet faultF11
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call the
service department.
Water inlet faultF12
Turn off the water tap and call the service department.Inlet valve leakageF40
Remove the plug from the wall socket and call the service
department.
Heater faultF41
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, call the service
department.
Clean the filters
(Water level fault)
F52
Turn off the water tap and call the service department.Overfilling water 2F54
Call the service department.Circ. pump faultF56
Press any button to clear the error message.
ActionPossible causesProblem
Wait a moment then try again.You have pressed the buttons
too soon after opening the door.
The buttons do not react when
pressed.
See the chapter Settings.Child lock (button lock)
activated.
Open the door. The buttons only
react to use when the door is
open.
The door is closed.
Clean with a dry or slightly damp
cloth.
The buttons are dirty.
Check that the baskets are
correctly positioned horizontally.
The baskets are not correctly
positioned.
Cannot close door.
Check that the dishes are not
blocking the baskets from
sliding properly into place.
29
Troubleshooting
To Next Page
Loading...
Need help?
General
