18
THE MACHINE WILL NOT START
Check that:
• The door is properly closed.
• The main switch is pressed in.
• You have correctly set the required time in
the timed program.
• The condensation water tank is emptied.
• The electric plug, if any, is plugged into its
socket.
• All fuses are intact. Switch two fuses over to
check. It is not always possible to see directly if
a fuse has blown.
• The overheating device has not triggered, see
below.
OVERHEATING PROTECTION
The overheating protection device switches
OFF the tumble dryer if the temperature beco-
mes too high, eg, because the lint filter is clog-
ged. If this happens, clean
the filter, empty the con-
densation water tank and
clean the condenser, see
Chapter 8, Care and clea-
ning. Then reset the overhea-
ting device by pressing the
block rubber button on the back of the machi-
ne.
9 TROUBLE SHOOTING
TUMBLE DRYING TAKES TOO LONG
Empty the water container and check that the
lint filter and the condenser are not clogged,
see Chapter 8, Care and Cleaning. Excessive
drying times can also be caused by the machine
being installed in a very confined space and by
the air in the room (which cools the machine)
becoming too warm. In this situation make sure
that ventilation is improved, eg, by opening
doors and/or windows.
To Next Page
Loading...
