15
1
2
CLEANING THE LINT FILTER
Clean the lint filter after each use.
If your water is very hard a deposit of lime
may be formed on the lint filter. Check when
cleaning lint from the filter if there is any sign of
lime, if so wash the lint filter by hand to remove
any deposits.
1.Grasp the filter handle and pull towards you.
2.Pull the lint filter out of
the holder.
3. Open the filter and remove fluff from all
sides of the filter by hand. Use a soft dry cloth
to remove any remaining fluff.
4. Replace the filter in the filter holder.
8 CARE - CLEANING
EMPTYING THE CONDENSATION WATER TANK
Empty the condensation water tank after each
tumble drying.
Pull out the condensation water tank, empty
the water and put the tank back.
If the tank becomes too full the program will
be interrupted. Empty the tank and press the
Start
button and the program will continue
from where it was interrupted, see also Chapter
9, Trouble shooting.
NOTE
Do not pull out the condensation water tank
while the tumble dryer is running.
CLEANING THE OUTSIDE OF THE MACHINE
Use a mild detergent to clean the panel and the
outside of the machine. Do not use any sol-
vents, they can damage the machine. Do not
spray the machine with water.
NOTE
Do not allow dust to accumulate round the
machine. Keep clean and cool around the tum-
ble dryer. Dust, heat and moisture prolong the
drying time.
NOTE
If limescale develops on the filter, rinse it in
water to remove the limescale.
Dry the filter thoroughly with a hand towel.
To Next Page
Loading...
