Asko T760 - Page 20

20
Buzzer
If you choose Buzzer ON, a signal will sound
for three seconds as the drying program ends.
1. With the
buttons select Buzzer ON
or OFF.
2.Press the
Enter
button once to acknowledge
and save your choice. You will now come
automatically to sub-heading:
Anti-Crease program
In this program the drum will continue to rota-
te intermittently, ie, three seconds every min-
ute at the end of the drying phase. You can
choose a program duration of 1, 2 or 3 hours.
The Anti-crease program prevents garments
from lying still in the same position and beco-
ming creased. This is a helpful option if you
cannot take out garments promptly at the end
of the tumbling phase.
If you have chosen Buzzer ON, a signal will
sound each time the drum rotates during this
program.
1.With the
buttons select how long
you wish the Anti-crease program to run.
2.Press the
Enter
button once to acknowledge
and save your choice.
You have now gone through all the options.
4 - TEMPERATURE
You can choose temperature Normal or Low.
1.Press the
Menu
button once.
2.With the
buttons select the desired
temperature, Normal or Low.
3.Press the
Enter
button once to acknowledge
and save your choice.
5 - DELAYED START
You can delay starting your drying program by
up to 12 hours.
If you select Delayed start at say five hours,
the machine will start five hours after you press
the start button.
When you step forward to the desired time it
will be shown together with the
symbol in
the lower right corner of the display.
When you wish to run your drying program
you can easily alter the time for Delayed start,
see Temporary alterations, in Chapter 8, Tumble
dry.
1.Press the
Menu
button once.
2.With the buttons choose how long
you wish starting of the drying program to be
delayed.
3.Press the
Enter
button once to acknowledge
and save your choice.
You have now compiled and saved your
own drying program.
The next time you wish to run this particular
program all you have to do is press the program
button that you chose initially as the basis for
your settings.
SHORT CUTS
If you do not wish to make changes in all of the
menu headings for your program you can simp-
ly jump past them.
To go to the next heading without making
any changes, just press the
Menu
# button once.