L4
L3
After taking the measures described below, turn
o the machine to exit error message mode.
L1 Overow Fault
1. Shut o the water tap.
2. See "Drainage error".
L2 Water Outlet Fault
Check:
• that nothing is stuck in the drain hose outlet.
• that the drain pump is not blocked by foreign
objects. Clean the pump. See the "Care and
maintenance instructions" chapter.
• that there are no kinks in the drainage hose.
After taking action, run the Drain program or
press the Door Opening button (key symbol) to
empty the machine. If this does not resolve the
problem, call the Customer Care Center.
L3 Water Inlet Fault
Check:
• that the tap on the water pipe is open.
• that the lter in the machine's ll valve is not
blocked.
Action:
1. Shut o the water tap.
2. Unscrew the hose.
3. Clean the lter in the machine's ll valve.
4. Screw the hose back on.
5. Turn on the tap.
6. Run the program again to check whether the
error has been xed.
7. If this does not resolve the problem, call the
Customer Care Center.
L4 Imbalance
The machine stops the spin cycle if there is too
much imbalance. The washing machine restarts
the spin cycle and hopefully the laundry is better
distributed in the drum. This procedure can be
repeated up to
10 times. If the machine still fails to nd a good
balance, the program jumps to the next step.
The error message requires no action.
To Next Page
Loading...
