28
Customer Care Center
1-800-898-1879
www.askona.com
Installation
Built-in installation
ASKO washers can be installed beneath a
cabinet or worktop with a height of 34" to 35"
(863 to 889 mm) or in a closet. There must be a
gap of about ½" (12 mm) all around the machine,
including between the rear edge of the machine's
top panel and the back wall. The opening width
must be at least 24½" (622 mm). Space must
also be available for the ll and drain hoses. See
the illustration below for measurements and
positions. If the washer is installed in a closet
the door must be left open while the washer is
running.
If the drain outlet is higher than 24"(610 mm), the
connections will need to be recessed.
To Next Page
Loading...
