Asko W6903 - Built-In Machine with Cover Door Fitted

Built-in machine with cover door
fitted
You can choose whether the door is hung on
the right or the left.
Follow these instructions:
1. Remove the Toe kick.
2. Remove the cover door by undoing the four
screws. Support the door while doing this.
Undo the screw holding the door magnet
in place.
Steel door
3. Remove the two cover washer screws on
the front of the steel door. Remove the
cover washers.
The machine
4. Remove the cover washers from the
hinges.
5. Remove the cover washers from the hinges
by pushing them sideways. Whether this
is to the right or left depends on how the
door is fitted on the machine.
The cover washer for the machine
hinges
6. Undo and move the 4 + 3 screws on the
hinges to the other side.
7. Replace the cover washers.
8. Refit the cover door.
39Customer Care Center
1-800-898-1879
www.askousa.com
Reversing the door