VAR8 / Variants - Installation Guide
5 Safety and
Precautions
5.5 Lithium Battery
Danger of explosion if battery is
incorrectly replaced. Replace only
with the same or equivalent type.
Dispose of battery carefully to
avoid environmental damage. Do
not dispose of battery in a fire.
5.1 Environmental
The temperature and humidity ranges shown
in the specifications for this product must not
be exceeded.
This equipment must not be installed in an
area that is subject to a corrosive atmosphere,
excessive moisture or may allow water or other
liquids to come into contact with the unit or its
external connections.
5.6 Unpacking and
Handling
The equipment should be unpacked and
inspected immediately on receipt. If damage
has occurred please advise your carrier or
supplier.
In the close proximity of some radio frequency
transmitters, the signal to noise ratio of this
product may be reduced. If this occurs, re-
location of the equipment or the signal cables
is recommended.
It is advisable to retain the original equipment
packing in the event that the equipment ever
needs returning for service.
Ensure that the name and address of the
Authorised Distributor from whom you
purchased the unit is recorded on the "Service
and Warranty" page of this manual for future
reference.
5.2 ESD
This product contains static-sensitive devices.
Observe ESD precautions when working on
the equipment with the cover removed.
5.6.1 Packing for Repair
5.3 EMC
EMC compliance is dependent on this unit
being wired in accordance with these
installation instructions.
All electronics assemblies must be
properly packed in ESD protective
packing for transport, to prevent
physical and ESD damage. Use of
non-ESD protective packing for
return for repair or service will
automatically invalidate the
warranty.
5.4 Electrical Safety
Always replace blown fuses with
the correct type and rating.
The filler material used for packing
for return for repair must be
antistatic or static dissipative, as
this may come into contact with
exposed connectors, wiring, or
PCB assemblies. The use of non-
conductive filler material may
cause damage to the electronic
assemblies reducing their
operational life, or even destroying
them, and it will automatically
invalidate the warranty.
Ensure adequately rated cables
are used for power supply.
!
!
!
!
!
!
!
!
!
!
Advice on packing the product for return can
be provided by Application Solutions Limited.
Issue: 01 complete, approved
Page 20 of 22
To Next Page
Loading...
Need help?
General
