VAR8 / Variants - Installation Guide
Issue: 01 complete, approved
Page 22 of 22
7 Service and Warranty
This product carries a full warranty. For full details of warranty and service agreements, please contact
the Authorised Distributor who supplied the product to you.
7.1 Exclusions
The warranty does NOT cover:
1. Customer misuse, including incorrect installation.
2. Damage other than manufacturing defects.
3. Transit / Courier damage.
4. Incorrect voltage or power supply used.
5. Incorrect input signal.
6. Abnormal environmental operating conditions.
7. Damage incurred by accident, fire, lightning or other hazard.
8. Modification to the unit or inexpert / attempted repair.
9. No fault found – where no fault can be found after extensive testing, indicating user error or
failure in ancillary equipment.
10. Electronic assemblies which are improperly packed when returned for repair or service. All
electronics assemblies must be properly packed in ESD protective packing for transport to
prevent physical and ESD damage. Use of non-ESD protective packing for return for repair or
service will automatically invalidate the warranty.
Should any of the above apply, Application Solutions Limited reserves the right to raise any relevant
charges to the customer.
Application Solutions Limited shall not be liable for any indirect, special or consequential loss or
damage (including without limitation any loss of profits) arising from the use of this product or for any
breach of this warranty.
Name and Address of Authorised Distributor:
In the interest of continual product development, Application Solutions Limited reserves the right to
make changes to product specification without notice or liability.
To Next Page
Loading...
