In the standby interface, press the dial key to show the dialed calls.
Press the up or down direction keys to select a number you want to dial and then press the Dial key.
Press the red End key to end the current conversation.
If you wish to increase or decrease volume during a call, simply click the up arrow or down arrow at top and
bottom of the menu key.
By default, opening the cover will answer a call. You can change this setting to give you an option to reject a
call. Go to phone settings->call settings->advanced settings->answer mode. Turn on the “any key” option
and make sure the cover answer and auto answer options are turned off.
When a phone call comes in, opening the cover will not answer the call and there will be “reject” call option.
Any other key that is pressed will effectively answer the incoming call.
Note: If the caller can be identified, the mobile phone will present the calling number. If the calling number
exists in the phonebook, the mobile phone will present both the name and the phone number of the caller. If
the caller cannot be identified, the phone number will present only. You can answer an incoming call when
using a function list or browsing the phonebook.
Select Options during a conversation to pause, end the ongoing call, originate a new call, browse the
phonebook, view information, set the mute, set the DTMF, or perform other operations. For details, refer to
the menu guide.
To Next Page
Loading...
