NOTE
Hot water outlet with control panel or line controller. The line controller is optional for
custom-ers. If without special request from customers, the unit will be equipped with no line
control-ler.
4. METHODS OF USING
17
Receptacle shall be installed on the left or right side of the unit and must be grounded reliably .
●
Insert the power supply plug and switch on the power.
●
Open the main gas valve switch.
●
Open the water inlet valve before ignition.
●
4.1 Preparation Before Ignition
① Insert the power plug
② Fully open the gas supply valve
③ Fully open the water supply valve
Be sure to open
fully before use
To Next Page
Loading...
