Aspes ACE648X - Page 38

EN
Note: The illustration is a reference image, your device may differ.
Prior to connecting the hood with the pipe, you should control the plastic flaps
at the product air exit point. Before making the pipe connection, operate the hood and
make sure the flaps move upwards correctly and allow air exit. Otherwise, change
direction of the flaps. (Figure 7)
Overtightening of the cable holder or clamp when making pipe connection may
prevent operation of the flaps. Prior to connecting the pipe with the chimney of your
house, you, therefore, control whether the hood operates properly by operating it.
(Figure 5)
(Figure 6)