ASROCK B650D4U - Jumper Setup

28 29
English
2.7 Jumper Setup
e illustration shows how jumpers are setup. When the jumper cap is placed on the pins,
the jumper is “Short”. If no jumper cap is placed on the pins, the jumper is “Open”. e
illustration shows a 3-pin jumper whose pin1 and pin2 are “Short” when a jumper cap is
placed on these 2 pins.
Chassis ID Jumper
(3-pin CHASSIS_ID0)
Pull-up, for BMC further
use (Default)
Pull-down, for BMC further
use