39
the red-striped side to Pin1
2.11 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.15 No. 31)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
SATA2_2_3 SATA2_4_5
SATA3_A3_A4 SATA3_A1_A2 SATA3_0_1
Primary IDE connector (Black)
(39-pin IDE1, see p.15 No. 8)
Note: Please refer to the instruction of your IDE device vendor for the details.
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATA2_2_3: see p.15, No. 13)
connectors support SATA data
(SATA2_4_5: see p.15, No. 12)
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
Serial ATA3 Connectors These six Serial ATA3 (SATA3)
(SATA3_0_1: see p.15, No. 14)
connectors support SATA data
(SATA3_A1_A2: see p.15, No. 15)
cables for internal storage
(SATA3_A3_A4: see p.15, No. 16)
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If you install
the HDD on the eSATA port on
the rear I/O, the internal
SATA3_A4 will not function.
To Next Page
Loading...
