LCU9101 9
Installation
The following section describes the physical installation of the
control unit and connection of accessories.
Installation Relay board DAC400RC64
To get access to all outputs and inputs relay board DAC400RC64
must be connected.
Connection of relay board is made as follows:
1. Turn off the power to LCU9101
2. Dislocate LCU9101 from the box
3. Align the contact pieces toward each other
4. Make sure that the boards are in level with each other
5. Push the boards together
6. Snap the boards to the box
7. Turn the power ON
LCU9101 + RC64 are ready for operation
To Next Page
Loading...
