To Next PageTo Next Page
Need help?Do you have a question about the Assa Abloy Norton D6021 Series and is the answer not in the manual?
General| Category | Garage Door Opener |
|---|---|
| Voltage | 120 VAC |
| Protection Rating | NEMA 1 |
| Brand | Assa Abloy |
| Series | D6021 |
| Type | Commercial Door Operator |
Explains the three operational modes: push plate, push & go, and manual use.
Details how the door opens, stops on obstruction, and the hold open time setting.
Describes how the door closes, stops on obstruction, and resets.
Details the optional feature to keep the door held open for extended periods.
Instructions for preparing the door frame, including determining push/pull and marking locations.
Steps for mounting the left and right backplates to the frame securely.
Final steps for securing backplates to the frame, ensuring proper alignment and support.
Details on preparing the doors by drilling holes for adjusting tubes and shoes.
Securing the end caps to the connected backplates using screws.
Mounting the Operator LAP (Linkage Arm Plate) to the backplates.
Connecting the conduit assembly to the backplate and wiring it to the building's power.
Securing the power module sub-assemblies to the backplates.
Connecting the power modules to the operator LAPs using provided connectors.
Mounting the union assembly and connecting it to the power module sub-assembly.
Installing the adjusting tubes and shoes onto the prepared doors using screws.
Sliding the main arm rod into the adjusting tube and onto the closer pinion.
Fine-tuning sweep, latch, and backcheck valves for proper closer function.
Setting the spring force on the closer body using the adjustment nut for desired opening effort.
Details of adjustable parameters and default settings on Screen 1 of the controller interface.
Details of adjustable parameters and default settings on Screen 2 of the controller interface.
Wiring diagram for fail-secure electric strikes on double doors.
Wiring diagram for 24VDC electric exit devices on double doors.
Wiring for executive function using hardwired connections on double doors.
Wiring for electric latch retraction exit devices for smoke ventilation systems.
Wiring for standard function using radio frequency transmitters on double doors.
Wiring for executive function using radio frequency transmitters on double doors.
Guides on setting dip switches, configuring hand-held transmitters, and push plates.
Common problems with the receiver and their solutions.
