Associated Electrics RC8B4.1e Team Kit - Differential and Shock Assembly - Steps 7-1; Center Differential Finalization; Shock Absorber Initial Assembly

7
:: :: Differential Build Differential Build (Center) (Center) - Bag - Bag 1.1, 1.21.1, 1.2 - Step 7 - Step 7
:: :: Differential Build Differential Build (Center) (Center) - Bag - Bag 1.1, 1.21.1, 1.2 - Step 8 - Step 8
Racer’s Tip:
Fill diff above the cross
pins, below the planet
gears as shown.
:: Shocks Build:: Shocks Build - - Bag 2.1 Bag 2.1 - Step 1- Step 1
81186
Shock
O-Ring
81185
O-Ring Hat
Bushing
81188
Shock Body
Seal
Retainer
x2x2
81172
TiN Shock Shaft,
3.5x33.5mm
(Front)
81185
O-Ring
Spacer
81185
Shock Body
O-Ring
81173
TiN Shock Shaft,
3.5x42.5mm
(Rear)
89278
2.6x6mm
Washer
89215
2.5mm Shock
Piston Locknut
x2x2
Align pin with
groove in sun gear
!
81380
Pin
2.5x12mm
81380
Diff Sun
Gear, 20T,
HTC
81384
Diff
Gasket
#6588
black grease
25202
3x10mm
FHCS
x4x4
Diff Fluid
Center Diff Fluid:
10,000cst #5455
!
Racer’s Tip:
Use black grease
(#6588) to coat
the back side of the
diff gasket (i.e. not
the entire gasket)
before installation!
81597
FT Shock Piston
(6x1.4 flat)
Front
81598
FT Shock Piston
(6x1.5 tapered)
Rear
81162
Shock Body,
26.5mm
(Front)
81163
Shock Body,
36.5mm
(Rear)
Install pistons
taper down
!