Associated Electrics RC8B4 - Page 28

28
:: Wheels / Tires / Body - Misc. - Step 2
:: Wheels / Tires / Body - Misc. - Step 3
Painting Tips:
Your kit comes with a clear polycarbonate
body. You will need to prep the body before
you can paint it. Wash the inside thoroughly
with warm water and liquid detergent. Dry
the body using a clean, soft, lint-free cloth.
Install the window masks on the inside of the
body. (RC cars get painted on the inside).
Using high quality masking tape, apply tape
to the inside of the body to create a design.
Spray (either rattle can or airbrush RC
specific paint) the paint to the inside of the
body (preferably dark colors first, lighter
colors last).
NOTE: use ONLY paint that is recommended
for use with (polycarbonate) plastics. If you
do not, you can destroy the polycarbonate
body!
After painting, cut the body along the trim
lines. Make sure to drill or use a body reamer
to make the holes for the body mounts and
antenna!
Install wheel nuts with the
serrated edge
towards the wheel.
!
Install wheel nuts with the
serrated edge
towards the wheel.
!
81082
Wheel Nuts,
17mm
(Blue)
x4
2208
Body Clip
81568
Body
x2
81568
Nose
Cone
31531
3x6mm
BHCS