Need help?Do you have a question about the Astell AMB440 and is the answer not in the manual?
Symbols for protective earth, dangerous voltage, hot surfaces, and warnings.
Symbol indicating that a qualified engineer is required for service.
Risks associated with electrical hazards, handling, and moving the unit.
Compliance with PED and requirements for safety valve testing.
Importance of log books, responsible persons, and operator training.
Defines the intended use and technical details of the equipment.
Measures to reduce user risks and information on accessories/spare parts.
Permitted operating conditions and electrical requirements.
Recommended testing frequency and how to access the test program.
Guidelines on intended use and factory default passwords.
Step-by-step guide for basic operation of the steriliser.
Function of power switch and cool lock thermostats.
Displayed measurements and how the alarm system functions.
Over-temperature thermostat and safety cut-out mechanisms.
Procedures for safely opening and closing the steriliser door.
How to navigate and select available sterilisation programs.
How to set a delayed start for a cycle.
Steps to start a cycle immediately after door lock.
How the system behaves after power interruptions during or before a cycle.
Procedures for assessing load safety after a successful cycle.
Risks and procedures when a cycle fails and the door cannot be opened.
Overview of user groups like OPERATORS, SUPERVISORS, SITE ENGINEERS.
Step-by-step guide to logging in and entering passwords.
Procedure to change the user's password.
Process for modifying or adding user names and their roles.
Initial setup steps for the CFR logging system.
Procedure for adding new users to the CFR system.
Procedures for locking and deleting user accounts.
Steps to enable the user logging feature.
Procedure for creating backups of audit files using a USB drive.
General| Type | Analytical Balance |
|---|---|
| Capacity | 440 g |
| Calibration | Internal or External |
| Pan Size | Ø 90 mm |
| Units | g, mg, ct, oz, lb, ozt, dwt |
| Interface | RS232 |
| Readability | 0.1mg |
To Next Page
