10
Instrument also works as 4_20 mA current simulator.It gives 4 mA & 20 mA
current for calibration of other instruments.Follow the below guideline:
Ast
er
T
c
n
olog
ies
e
h
IN CASE OF RS-485 OUTPUT:
In case of Flow meter with RS-485 output,if number of instruments are
connected through same wire then each instrument should have it’s specific
address(called as meter address).To set the meter address follow the
below guideline.
Actual value
MENU
Use VIEW & ACK.key to change the address.
ENTER THE PASSWORD 0345 USING VIEW & ACK. KEY
KEY TO BE PRESSED DISPLAY
PASS
VIEW & ACK
MENU
Addr
Previously set meter address
ENTER THE PASSWORD 0420 USING VIEW & ACK. KEY
20 mA
KEY TO BE PRESSED DISPLAY
PASS
VIEW & ACK
MENU
MENU
4 mA
Instrument will give 4 mA current
Instrument will give 20 mA current
End
MENU
Actual reading
MENU
To change the SPAN settings follow below guideline:
Menu
000.00 m3/hr.
previously set value
Required value can be set by scroll & select ch key.
Scroll & select ch simultaneously
PASSWORD :000
Enter the password 678 using scroll & select ch keys
Menu
SPN
To Next Page
Loading...