Astralpool APH3 INVERBOOST - Page 38

- 34 -
7.6.2 Press 5S and then press to check the parameter from P0-P7.
7.6.2.1 When there is on one parameter checking, Press again, and then press or to setting relative
parameter.
7.6.2.2. When there is on parameter checking Current time, Press again to set the HOUR, then press
or to adjust
“
HOUR
”
from 0-23. Press once again to set the MINUTE, press or to adjust
the MINUTE from 0 to 59. and press to save the new setting.
7.6.2.3. When there is on parameter checking Timer on setting, Press again to set the HOUR, then press
or to adjust
“
HOUR
”
from 0-23. Press again to set the MINUTE, press or to
adjust the MINUTE from 0 to 59. and press to save the new setting.
7.6.2.4. When there is on parameter checking Timer off setting, Press again to set the HOUR, then press
or to adjust
“
HOUR
”
from 0-23. Press again to set the MINUTE, press or to
adjust the
“
MINUTE
”
from 0 to 59. and press to save the new setting.
Code
Name
Range
Default
Remark
P0
Mandatory defrosting
0-1
0
0: defrosting mode;1: mandatory defrosting.
P1
Working mode
0-2
1
1: heating mode,0: cooling mode, 2:Auto
mode
P2
Timer on/off
0-1
0
1:Timer on/off is under function，0:Timer
on/off
is out of function (The setting of P5 and P6
won’t work)
P3
filtration pump
0-1
0
1:Always running，
0:Depends on the running of compressor
P4
Current time
HH:MM
00：00
0-23:0-59
P5
Timer on
HH:MM
00：00
0-23:0-59
P6
Timer off
HH:MM
00：00
0-23:0-59
P7
T1 Inlet water temp.
correction
-9～9
0
Default setting: 0
P8
Debug mode
0-1
0
1:P9，P10，P11(could be adjusted)
0: automatic(not adjusted)
P9
Compressor frequency
18-110
50
Manual adjustment
P10
EEV Initial opening
0-470
350
Manual adjustment
P11
DC fan speed
300-1000
500
Manual adjustment
P12
MODBUS COM
0 - 5
0
Only Modbus function
P13
MODBUS ID Address..
1 - 88
9
Only Modbus function
7.
7.
7.
Start-up
Start-up
Start-up
of
of
of
the
the
the
Heat
Heat
Heat
Pump
Pump
Pump