Operating the pool cleaner - Power button
a. Power LED
The blue LED flashes when the power supply is in standby mode and lights
continuously when the pool cleaner is operating.
b. "POWER" button
The button switches between "ON" and "STANDBY".
IMPORTANT- After every cycle the pool cleaner will automatically go to "standby".
In case you want to turn the machine off during the working cycle, press the
"power" button once and the LED will start flashing, indicating that the machine
has stopped running.
Shut off and unplug the power supply every time you remove the cleaner from the water.
It is recommended to clean the filter after every cycle.
Periodically straighten out the floating cable.
Save your cleaner's packaging for off-season storage or for shipping the unit to your
dealer if service is required.
Do not leave your cleaner in direct sunlight when not in use.
Never leave the power supply in direct sunlight and avoid leaving it in the
rain.
Occasionally, you should rinse your cleaner in clean, fresh water. This will
lengthen the service life of your cleaner.
Clean the propeller once a month
Important Tips
12
To Next Page
Loading...
