Astralpool POOL BASIC - System Operation and Alarms; Typical Swimming Pool Application; Alarm and Display Functions; Relay Actions

0000137934 rev. 1.0
6
Alarm
Display
Relay
Actions to do
Level
Level 7,2 ph
Alarm Relay Close
- Push Enter Key to open
Alarm Relay
- Restore Product tank
OFA First Alarm (time >70%)
Ofa alarm 7,2 ph
Alarm Relay open
- Push Enter Key to reset
OFA Second Alarm (time =100%)
Ofa stop 7,2 ph
Alarm Relay Close
- Push Enter Key to reset
Flow Rate
Flow 7,2 ph
Alarm Relay open
- Restore Flow Rate
System Error
Parameter error
Alarm Relay Open
- Press Enter Key to replace
Default parameter
- Destroy Unit
Calibration Function
Error 7 ph Error 4 ph
Error 465 mv
Alarm Relay open
- Restore Probe or Buffer
solution and repeat calibration
function
To restore Default parameters run Following steps:
• Power off Pool Basic unit
• Keeping Press UP and DOWN Key switch on the Power.
• The unit will flash Init.default no
• Press up Init.default Yes
• Enter Key to restore Default parameters.
Default parameters:
• Language = UK
• Set Point value= 7,4 pH; 750 mV (Rx)
• Dosing Method = Acid; Low (Rx)
• Time OFA = OFF
• Calibration = Full
• Flow Input= OFF
•
Type dosing= PROP
set
esc
enter
cal
prog
CAL
ENT
ESC
MODE
prog