To Next PageTo Next Page
Need help?Do you have a question about the Astralpool VRAC III Basic Series and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Series | Basic Series |
| Power Consumption | 10W |
| Protection Degree | IP 65 |
| Power Supply | 230V AC, 50Hz |
| Operating Temperature | 0°C to 50°C |
| Compatibility | Compatible with Astralpool equipment |
Details technical specifications like valve models, materials, pressure ratings, power supply, and protection degree.
Explains hydraulic connections and flow paths for filtration, backwash, rinse, closed, and recirculation.
Provides warnings for connecting the valve to the filter, including thread sealing and pipe links.
Outlines control cabinet requirements and connections to the electronic module, including power supply.
Illustrates a wiring diagram for connecting the valve to a 230V electrical cabinet.
Details the function of the safety fuse on the electronics board and its importance.
Provides step-by-step instructions for adjusting the pressure switch to set backwash triggers.
Recommends using an electrovalve in the drainage circuit to prevent water loss during power outages.
Covers regular maintenance of hydraulic components like skimmer baskets and pre-filters.
Details internal valve maintenance, including greasing O-rings and reassembling components.
States conditions for guarantee validity, emphasizing correct installation and maintenance.
Describes the function of push buttons and LEDs on the valve's control panel.
Explains how washing and rinsing cycles are initiated and managed.
Details automatic wash initiation based on elapsed time intervals (24h, 7 days).
Describes manually starting a wash + rinse routine using the control panel button.
Explains automatic wash initiation triggered by filter pressure exceeding a set threshold.
Details how to set wash and rinse times using the control panel and programming clock.
Details manual and forced drainage operations.
Manual drainage initiation from the filtration position.
Forced drainage operation during the timer program.
Explains how to manually place the valve in the closed position and its behavior.
Details how to activate the recirculation function and its behavior.
Describes fault codes indicated by LED flashing patterns and troubleshooting steps.
Step-by-step guide to safely remove the electronic module from the valve.
Procedures for correctly installing the electronic module onto the valve assembly.
Steps to temporarily convert to manual valve operation by dismounting the module.
Instructions for converting the valve back from manual to automatic operation.
A comprehensive guide to identifying and resolving common operational issues with the valve.
