What does 'low ambient temperature protection' mean for my Astralpool PRO ELYO INVERBOOST NN?
The 'low ambient temperature protection' message on your Astralpool Heat Pump indicates that the unit is either being used outside of its intended environment or that there is a sensor abnormality. Stop using the unit if it is beyond its operating scope, or change the sensor.
What causes piping temperature too high protection under cooling mode T3 in Astralpool PRO ELYO INVERBOOST NN Heat Pump?
Piping temperature too high protection under cooling mode T3 in your Astralpool Heat Pump can be caused by a high ambient or water temperature, or an abnormal refrigeration system. Check the scope of using and the refrigeration system.
What to do if my Astralpool PRO ELYO INVERBOOST NN Heat Pump displays IPM module protection?
If your Astralpool Heat Pump displays an IPM module protection error, it could be due to a data mistake, wrong compressor phase connection, compressor liquid and oil accumulation, or a damaged compressor or driver board. You can try turning off the electricity supply and restarting after 3 minutes, changing the driver board, or checking the compressor sequence connection.
What does 'VDC voltage too low protection' mean for my Astralpool Heat Pump?
The 'VDC voltage too low protection' error in your Astralpool Heat Pump indicates that the line voltage is too low or the driver board is damaged. Check if the power is in the normal range or change the driver board.
What causes input current over high protection in my Astralpool PRO ELYO INVERBOOST NN?
Input current over high protection in your Astralpool Heat Pump can be caused by a large momentary compressor current, abnormal water flow, power fluctuations, or an incorrect PFC inductor. Try checking the compressor, the waterway system, the power range, and if the correct PFC inductor is used.
How to troubleshoot IPM module thermal circuit abnormality in Astralpool Heat Pump?
An abnormal IPM module thermal circuit in your Astralpool Heat Pump can be caused by an output abnormality of the IPM module thermal circuit or a problem with the fan motor (abnormal or damaged) or a broken fan blade. Try changing the driver board, checking if the motor speed is too low or fan motor is damaged, or changing the fan blade.
What to do if my Astralpool Heat Pump shows IPM module temperature too high protection?
If your Astralpool Heat Pump displays an IPM module temperature too high protection error, it could be due to an output exception of the IPM module thermal circuit, an abnormal or damaged motor, or a broken fan blade. Try changing the driver board, checking if the fan motor speed is too low or fan motor is damaged, or changing the fan blade.
Wiring diagram for inverter pool heat pumps (Models 71676/71677/71678/71679/71680).
Wiring diagram for inverter pool heat pumps (Model 71681).
Wiring diagram for inverter pool heat pumps (Models 71682/71683).
Wiring diagram for inverter pool heat pumps (Model 68822 (R410A)).
Wiring diagram for inverter pool heat pumps (Models 68821/68823 (R410A)).
Guidelines and requirements for the electrical connection of the heat pump.
Describes the logic and conditions for heating operation modes.
Lists error codes, their reasons, and solutions for LED wire controller displays.
Troubleshooting guide for malfunctions not indicated by error codes on the controller.
General| Category | Heat Pump |
|---|---|
| Max Water Temperature | 40°C |
| Refrigerant | R32 |
| IP Rating | IPX4 |
| Ambient Temperature Range | 43°C |
To Next Page