If you click zero times, the floor or ceiling value doesn’t change. This is great because you can change just the floor
or just the ceiling without reprogramming the other.
The EC01 has a nice candlelight mode, the effect is bigger if you use a diffuser.
Lightning storm is also more fun with a diffuser.
Searching things:
If you drop a little piece, lay your light flat on the ground and rotate it like a lighthouse. The small piece should cast a
long shadow and it is easier to find.
In case you lose your light, you can store a piece of paper in the tube with: “This Lamp belongs to NAME. If found
please call: 1234 or Name@mail.com.
General voltage level of a Lion battery
Voltage Note for a 21700
4.2 V fully charged
3.7 V half full *
3.1 V below 10% capacity, time to charge *
2.8 V low voltage protection from a lamp should start
2.5 V begin of deep discharge
Pay attention that the voltage level under load is lower than without load.
*on these two entries, please note smaller battery sizes (e.g. 16350, 18350) have a bit higher voltages.
There are also some other interfaces available for this hardware, but it requires the user to flash different firmware.
You can make it work like other brands. However, these are not tested and not officially supported.
Links
Changes in Andúril: Commit log (instead a change log):
https://bazaar.launchpad.net/~toykeeper/flashlightfirmware/fsm/changes
UI Diagram from ToyKeeper:
http://toykeeper.net/torches/fsm/anduril-ui.png
Stable firmware from:
Bazaar Launchpad resp. http://tiny.cc/TKAnduril
Newest HEX from: http://toykeeper.net/torches/fsm/
FSM Thread:
Andúril is part of a bigger framework called FSM. You can choose from different user interfaces.
http://budgetlightforum.com/node/56105
A YouTube Video with a Andúril walk through: How to use and set up ToyKeeper’s Andúril flashlight firmware from
Tech-test
https://youtu.be/h_mZ35IPLMA
Hoops Flashing Firmware thread:
http://budgetlightforum.com/node/36216
FAQ EC01
You tried to configure your lamp and now it is only working if you press the button. When you press 4x from
OFF you lock out the lamp. Press four times again to unlock. When you want to config the lamp must be ON,
and then click four times.
If I turn on using moon shortcut, it won’t memorize moon.
To Next Page
Loading...