Control of Switch LEDs – Defaults EC01
Setting Regular OFF In LOCKOUT
Change setting via 7 clicks 3 clicks
Off-Low-High-Beacon Low Beacon
Protection Features
Some features which aren’t visible on the diagram: Andúril includes low voltage protection (LVP) and thermal
regulation.
LVP makes the light step down to a lower level when the battery is low, and if the light is already at the lowest level, it
shuts itself off.
This activates at 2.8V. LVP adjustments happen suddenly, in large steps.
Thermal regulation attempts to keeps the light from overheating and otherwise adjusts output to stay as close as
possible to the user-configured temperature limit. Thermal adjustments happen gradually, in steps so small they are
difficult for humans to perceive. It ramps smoothly across 512 internal steps (from 1×7135 to full power) to adjust
output while it searches for the highest level it can maintain without overheating.
Usage of the flashlight
You can do a little bit more with your new light …
Because the EC01 is a high powered light, it is recommended to use lockout. It can burn things! Backside is, a
normal lockout is awkward if you need quick little illumination for the keyhole or in your bag.
EC01 LOCKOUT mode doubles as a momentary moon mode. That way, after locking it and tossing it in a bag, it can
still be used to look around inside the bag without unlocking it.
Lockout uses as moonlight the floor of the current ramp. If you have two different settings for this, you can have
different illumination also.
Or you can use Muggle Mode if you want a safer way to carry your lamp with a reduced output and don’t want lock
out.
While on, a double click toggles between turbo and the memorized level. So, if you hear a noise and want full power
for a moment, double click. When you’re done, double click again to return to the original brightness. This is handy
for walking the dog: With low you can stroll, and when your dog runs away: TURBO, when he comes back, low
again.
Now you can play with FLOOR, CEILING and two ramps
e.g.: Let’s say your favorite is smooth ramping and you don’t like the quick step down from a ceiling at level 130. You
can choose level 101 (50 clicks) for the smooth ramp ceiling. This keeps the ceiling at a reasonable cooler level.
Smooth floor on level 1 for a really dim moonlight. You can set 20 clicks for stepped floor for a usable low outdoors.
And 130 for stepped ceiling if you also like to have a powerful ceil.
An option against too much heat can be different ceilings for SMOOTH RAMP and STEPPED RAMP. Lower for your
preferred ramp the ceiling and with 3 clicks
you can switch to the other ramp, where you can have full power if you need it.
To Next Page
Loading...