Asus Gryphon Z97 - Page 89

ASUS GRYPHON Z97
3-21
Chapter 3
The following item appears only when you set the CPU VRM Switching Frequency to
[Manual].
Fixed CPU VRM Switching Frequency (KHz) [300]
This item allows you to set a higher frequency for a quicker transient
response speed. Use the <+> or <-> to adjust the value. The values range
from 300 KHz to 500 KHz with an interval of 50 KHz.
VRM Spread Spectrum [Disabled]
This item allows to enhance the system stability.
Conguration options: [Disabled] [Enabled]
CPU Power Phase Control [Auto]
This item allows you to set the power phase control of the CPU.
Conguration options: [Auto] [Standard] [Optimized] [Extreme]
CPU Power Duty Control [T.Probe]
DIGI + VRM Duty Control adjusts the current of every VRM phase and the thermal
conditions of every phase component.
[T. Probe] Select to maintain the VRM thermal balance.
[Extreme] Select to maintain the current VRM balance.
DO NOT remove the thermal module. The thermal conditions should be monitored.
CPU Current Capability [Auto]
This item provides a total power range for CPU overclocking. A higher value setting
provides higher power consumption delivery and extends the overclocking frequency
range simultaneously.
Conguration options: [Auto] [100%] [110%] [120%] [130%] [140%]
DRAM Current Capability [100%]
This item adjusts the total power range for DRAM overclocking. Set a higher value
to provide a wider total power range and extends the overclocking frequency range
simultaneously.
Conguration options: [100%] [110%] [120%] [130%]
DRAM Switching Frequency [Auto]
This item affects the overclocking range and system stability. Set this item to [Manual]
to manually set a xed DRAM switching frequency for an increased overclocking range
or enhanced system stability.
The following item appears only when you set the DRAM Switching Frequency to [Manual].
Fixed DRAM Switching Frequency (KHz) [300]
This item allows you to set a higher frequency for an increased
overclocking range or a lower frequency for an enhanced system stability.
Use the <+> or <-> to adjust the value. The values range from 300 KHz to
500 KHz with an interval of 50 KHz.