Asus M4A79XTD - Motherboard - ATX - 4.4.3 Setting the RAID item in BIOS

ASUS M4A79XTD EVO 4-13
Chapter 4
4.4.4 AMD
®
Option ROM Utility
®
To enter the AMD
®
Option ROM utility
®
1. Boot up your computer.
2. During POST, press <Ctrl> + <F> to display the utility main menu.
4.4.3 Setting the RAID item in BIOS
You must enable the RAID function in the BIOS Setup before creating RAID volume(s) using
SATA HDDs. To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Main menu > Storage Conguration, and then press <Enter>.
3. Set the OnChip SATA Type item to [RAID].
4. Save your changes, and then exit the BIOS Setup.
Refer to Chapter 3 for details on entering and navigating through the BIOS Setup.
Due to chipset limitation, when set any of SATA ports to RAID mode, all SATA ports run at
RAID mode together.
4.4.2 Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance, install
identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID conguration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
Option ROM Utility (c) 2008 Advanced Micro Devices, Inc.
[ Main Menu ]
View Drive Assignments........[1]
Dene LD................. ....[2]
Delete LD.....................[3]
Controller Conguration... ...[4]
[ Keys Available ]
Press 1..4 to Select Option [ESC] Exit