ASUS P3V4X User’s Manual 69
4. BIOS SETUP
4. BIOS SETUP
Power Up Control
AC PWR Loss Restart [Disabled]
This allows you to set whether you want your system to reboot after the
power has been interrupted. [Disabled] leaves your system off and [En-
abled] reboots your system if it was active before power loss. [Previous
State] sets your system back to the state it is before the power interruption.
Configuration options: [Disabled] [Enabled] [Previous State]
PWR Up On External Modem Act [Enabled]
This allows either settings of [Enabled] or [Disabled] for powering up the
computer when the external modem receives a call while the computer is in
Soft-off mode. NOTE: The computer cannot receive or transmit data until
the computer and applications are fully running, thus connection cannot be
made on the first try. Turning an external modem off and then back on while
the computer is off causes an initialization string that will also cause the
system to power on. Configuration options: [Disabled] [Enabled]
Wake On LAN or PCI Modem [Disabled]
Wake-On-LAN or a PCI modem card allows your computer to be booted
from another computer via network or dialup connection by sending a wake-
up frame or signal. Configuration options: [Disabled] [Enabled]
IMPORTANT: This feature requires an optional network interface with Wake-On-
LAN and an ATX power supply with at least 720mA +5V standby power.
4.5.1 Power Up Control
To Next Page
Loading...
Need help?
General
