EasyManua.ls Logo

Asus P5KPL EPU - Intel(R) SpeedStep(TM) Tech [Enabled]; 2.4.4 Chipset; North Bridge Configuration; Memory Remap Feature [Enabled]

Asus P5KPL EPU
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ASUS P5KPL/EPU 2-13
Intel(R) SpeedStep(TM) Tech [Enabled]
Allows you to use the Enhanced Intel
®
SpeedStep
®
Technology. When set to
[Enabled], you can adjust the system power settings in the operating system to
use the EIST feature. Set this item to [Disabled] if you do not want to use the EIST.
Conguration options: [Enabled] [Disabled]
2.4.4 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then
press <Enter> to display the submenu.
North Bridge Conguration
Memory Remap Feature [Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI memory above the
total physical memory. Enable this option only when you install 64-bit operating system.
Conguration options: [Disabled] [Enabled]
Congure DRAM Timing by SPD [Enabled]
Allows you to enable or disable conguring the DRAM Timing by SPD.
Conguration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Conguration options: [PCI/PEG] [PEG/PCI]
South Bridge Conguration
Audio Controller [Azalia]
Allows you to set the audio controller. Conguration options: [Azalia] [Disabled]
Front Panel Support Type [HD Audio]
Allows you to select the front panel support type. If High Denition Audio Front Panel
used, please set HD Audio mode. Conguration options: [AC97] [HD Audio]
2.4.5 Onboard Devices Conguration
Onboard LAN [Enabled]
Allows you to enable or disable the onboard LAN controller.
Conguration options: [Enabled] [Disabled]
OnBoard LAN Boot ROM [Disabled]
Allows you to enable or disable the boot ROM in the onboard LAN controller. This item
appears only when the Onboard LAN item is set to Enabled. Conguration options:
[Disabled] [Enabled]
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Conguration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]

Table of Contents

Related product manuals