5. IDE connector (40-1 pin PRLEIDE)
The onboard IDE connector is for the Ultra DMA 100/66 signal cable. There are three
connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the
blue connector to the motherboard's IDE connector, then select one of the following
modes to configure your device.
Drive jumper setting Mode of devicefs) Cable connector
Single device
Cable-Select or Master Black
Two devices
Cable-Select
Master
Slave
Black
Gray
Two devices
Master Master
Black or gray
Slave Slave
Black or gray
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
P5KPUEPU IDE connector
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
1-24
Chapter 1: Product introduction
To Next Page
Loading...
