Intel(R) SpeedStep/TM) Tech [Enabled}
Allows you to use the Enhanced InteP SpeedStep® Technology. When set to
[Enabled], you can adjust the system power settings in the operating system to
use the EIST feature. Set this item to [Disabled] if you do not want to use the EIST.
Configuration options: [Enabled] [Disabled]
2.4.4 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then
press <Enter> to display the submenu.
North Bridge Configuration
Memory Remap Feature [Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI memory above the
total physical memory. Enable this option only when you install 64-bit operating system.
Configuration options: [Disabled] [Enabled]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configuring the DRAM Timing by SPD.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
South Bridge Configuration
Audio Controller [Azalia]
Allows you to set the audio controller. Configuration options: [Azalia] [Disabled]
Front Panel Support Type [HP Audio]
Allows you to select the front panel support type. If High Definition Audio Front Panel
used, please set HD Audio mode. Configuration options: [AC97] [HD Audio]
2.4.5 Onboard Devices Configuration
Onboard LAN [Enabled]
Allows you to enable or disable the onboard LAN controller.
Configuration options: [Enabled] [Disabled]
OnBoard LAN Boot ROM [Disabled]
Allows you to enable or disable the boot ROM in the onboard LAN controller. This item
appears only when the Onboard LAN item is set to Enabled. Configuration options:
[Disabled] [Enabled]
Serial Portl Address [3F8/IRQ4]
Allows you to select the Serial Portl base address.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/1RQ4] [2E8/IRQ3]
ASUS P5KPL/EPU
1-13
To Next Page
Loading...
